HealthRider HRTL34305.0 User Manual download pdf (Page 6)

. With the help of a second person, position the treadmill

with the Uprights (62, 76) in the vertical position as

hown.

oute the Wire Harness (21) through the bracket on the

Right Handrail (47) and out the large hole on the side of

the Right Handrail. Insert the bracket on the Right

Handrail into the top of the Right Upright (62). Attach the

ight Handrail with two 1” Bolts (8) and two 1/4” Star

Washers (9) as shown. Do not tighten the Bolts yet.

Attach the Left Handrail (not shown) as described above.

Note: There is not a wire harness on the left side.

4. Hold the Crossbar (34) between the Handrails (1, 47).

Attach the Crossbar with two Crossbar Screws (53) and

two Crossbar Star Washers (88). Do not tighten the

Crossbar Screws yet.

Hold the Console (10) and the Console Base (46) near the

Handrails (1, 47). See the inset drawing. Route the

ground wire (A) from the Console Base through the open-

ing at the side of the Console Cover (96). Next, route the

ground Wire through the two indicated plastic ties on the

Console Base.

Attach the end of the ground wire (A) to the small hole in

the side of the Right Handrail (47) with a Silver Ground

Screw (91).

Large

ole

racket

Ties

5. Place the Console Base (46) on the Right Handrail (47)

and the Left Handrail (not shown). Attach the Console

Base with four 3/4” Screws (13) (only two Screws are

shown). Do not tighten the Screws yet.

Insert the Wire Harness (21) through the two indicated

plastic ties on the Console Base (46). Next, insert the

Wire Harness up through the indicated opening in the

Console Base. Make sure that the Console Cover (96) is

securely attached to the Console Base.

See the inset drawing. Look at the top of the Console

Base (46). Insert the Wire Harness (21) through the plas-

tic tie on top of the Console Base.

Tie

Ties

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

No comments

HealthRider HRTL34305.0 User Manual Page 6