HealthRider H500i User Manual download pdf (Page 20)

Locate the Reed Switch (63) and the Magnet (46) on

the left side of the Front Roller (47). Turn the Front

oller until the Magnet is aligned with the Reed Switch.

Make sure that the gap between the Magnet and

he Reed Switch is about 1/8 in. (3 mm).

f neces-

sary, loosen the 3/4" Screw (7), move the Reed Switch

slightly, and retighten the Screw. Reattach the Hood

(not shown), making sure that the 3/4" Screws (not

shown) are inserted into the same holes from which

they were removed. Run the treadmill for a few minutes

to check for a correct speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all the specifications described on page 10.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be-

come damaged. Remove the key and UNPLUG THE

POWER CORD

. Using the hex key, turn both rear

roller bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 2 to 3 in. (5 to 7

cm) above the walking platform. Be careful to keep

the walking belt centered. Then, plug in the power

cord, insert the key, and run the treadmill for a few

minutes. Repeat until the walking belt is properly tight-

ened.

c. If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:

a. If the walking belt is off-center, first remove the key

and UNPLUG THE POWER CORD. If the walking

belt has shifted to the left, use the hex key to turn

the left rear roller bolt clockwise 1/2 of a turn; if the

walking belt has shifted to the right, turn the left

bolt counterclockwise 1/2 of a turn. Be careful not to

overtighten the walking belt.

Then, plug in the power

cord, insert the key, and run the treadmill for a few

minutes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first re

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both rear roller bolts clock-

wise, 1/4 of a turn. When the walking belt is correctly

tightened, you should be able to lift each edge of the

walking belt 2 to 3 in. (5 to 7 cm) above the walking

platform. Be careful to keep the walking belt centered.

Then, plug in the power cord, insert the key, and care-

fully walk on the treadmill for a few minutes. Repeat

until the walking belt is properly tightened.

View

/8 in.

Rear Roller Bolts

2–3 in.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

HealthRider H500i User Manual Page 20

Comments to this Manuals

Related products and manuals for Treadmills HealthRider H500i