HealthRider HRSY23080 User Manual download pdf (Page 7)

9. Place the bracket on the lower end of the Weight

Upright (2) over the indicated 3/8Ó x 2 3/4Ó Carriage

Bolts (45) in the Weight Base (5). Hand tighten two

3/8Ó Nylon Locknuts (50) onto the Bolts. Do not tight-

en the Nylon Locknuts yet.

Locate two 3/8Ó x 1 3/4Ó Bolts (57) and slide a 3/8Ó

Flat Washer (55) onto each of them. Insert the Bolts

through the indicated holes in the Weight Upright (2)

and then through the bracket on the Support Upright

(3). Secure the Bolts with two 3/8Ó Nylon Locknuts

(50).

Go back and fully tighten all Nylon Locknuts used

in steps 2 through 9.

7. Locate two 3/8Ó x 4 3/4Ó Bolts (46) and slide a 3/8Ó

Flat Washer (55) onto each of them. Insert the Bolts

through the indicated holes in the Top Frame (9) and

then through the holes in the Main Upright (1). Slide a

3/8Ó Flat Washer onto each Bolt and secure it with a

3/8Ó Nylon Locknut (50). Do not tighten the Nylon

Locknut yet.

8. Slide a 3/8Ó Flat Washer (55) onto a 3/8Ó x 4 3/4Ó Bolt

(46) and push the Bolt through the Top Frame (9).

Push the Bolt into the hole in the Support Upright (3)

until the tip of the Bolt is visible inside the Upright.

Slide the 1/2Ó x 1 13/16Ó Bushing (84) down into the

Upright and push the Bolt all the way through the

Bushing and the Upright. Note: Make sure you donÕt

drop the Bushing into the Upright!

Slide a 3/8Ó Flat Washer (55) onto the Bolt and

secure it with a 3/8Ó Nylon Locknut (50). Do not

tighten the Nylon Locknut yet.

Slide a 3/8Ó Flat Washer (55) onto a 3/8Ó x 2 3/4Ó Bolt

(47) and insert the Bolt through the hole in the

Support Upright (3) and the bracket on the Top Frame

(9). Hand tighten a 3/8Ó Nylon Locknut (50) onto the

Bolt. Do not tighten the Nylon Locknut yet.

Bracket

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

No comments

HealthRider HRSY23080 User Manual Page 7