HealthRider HRSY23080 User Manual download pdf (Page 12)

26. Route the end of the High Cable (73) with the loop

through the bracket on the Main Upright (1) from

above. Route the High Cable over a 3 1/2Ó Pulley (24)

in the direction shown.

Slide the 3 1/2Ó Pulley (24) into the bracket on the

Main Upright (1). Slide a 3/8Ó x 3Ó Bolt (53) through

the bracket and the Pulley, but do not mount a

Locknut yet.

Bracket

27. Locate the Adjustable Pulley Frame (23) and remove

the 3 1/2Ó Pulleys (24) and Cable Traps (25).

Wrap the High Cable (73) around a 3 1/2Ó Pulley (24)

in the direction shown. Attach the 3 1/2Ó Pulley and a

Cable Trap (25) to the top half of the Adjustable

Pulley Frame (23) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó

Nylon Locknut (50). Note: The Pulley must be

attached to the upper of the three adjustment

holes. Make sure the Cable Trap is oriented as

shown.

Route the end of the High Cable (73) with the loop

through the bracket on the Main Upright (1) from

below.

25. Identify the High Cable (73). It is approximately

340Ó long and it has a ball on one end and a loop

on the other.

Route the end of the High Cable (73) with the loop

through the slot in the Main Upright (1).

Wrap the end of the High Cable (73) with the ball

around a 3 1/2Ó Pulley (24) as shown.

Attach the 3 1/2Ó Pulley (24) inside the slot in the

Main Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (59), two

3/8Ó Flat Washers (55), two 5/8Ó x 1Ó Bushings (86)

and a 3/8Ó Nylon Locknut (50).

Slot

24. Thread the bolt at the end of the Low Cable (72) a

couple of turns into the Weight Tube (17).

Bolt

Bracket

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

No comments

HealthRider HRSY23080 User Manual Page 12