HealthRider HRSY54370 User Manual download pdf (Page 14)

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The

home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLE

Woven cable, the type of cable used on the home

gym system, can stretch slightly when it is first used.

If there is slack in the cables before resistance is felt,

the cables should be tightened. Slack can be

removed from the Cable (35) by moving the Pulley

(41) to the next hole in the indicated bracket on the

upper end of the Frame (2). Remove the 3/8Ó Nylon

Locknut (39) and the 3/8Ó x 2Ó Bolt (43) from the

Cable Trap (67) and Pulley. Re-attach the Pulley and

Cable Trap to the next hole in the bracket. Be sure

that the Cable Trap is in the proper position and that

the Cable and Pulley move smoothly.

Additional slack can be removed by moving the

Pulley (41) to the upper hole in the indicated bracket

on the back of the Frame (2). Remove the 3/8Ó Nylon

Locknut (39) and the 3/8Ó x 2Ó Bolt (43) from the

Pulley. Re-attach the Pulley to the upper hole in the

bracket. Be sure that the Cable and Pulley move

smoothly.

Note: If a cable tends to slip off the pulleys often,

the cable may have become twisted. Remove the

cable and re-install it.

The cable must be replaced every two years. If the

cable needs to be replaced, see ORDERING

REPLACEMENT PARTS on the back cover of this

manual.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

HealthRider HRSY54370 User Manual Page 14