HealthRider T90 User Manual download pdf (Page 8)

8 . Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a

secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet

from damage, place a mat under the treadmill.

5. Insert two Handrail Bolts (111) with Handrail Washers

(112) into the right Upright (110) and the Right Handrail

Spacer (107). Lift the right Handrail (89) slightly and align

the Bolts with the holes in the Handrail. Loosely thread

the Bolts into the Handrail. Do not tighten the Bolts yet.

Refer to step 3. Remove the Handrail Bolt (111) from the

left Upright (110) and the left Handrail (89).

Place the Left Handrail Spacer (106, not shown) on the

left Upright (110, not shown). Attach the left Handrail (89)

as described above. Tighten all four Handrail Bolts (111).

111

112

110

4. Pull the Upright Wire Harness (101) and the TV Cable

(104) up through the Right Handrail Spacer (107) (refer to

drawing A to distinguish the Right Handrail Spacer from

the Left Handrail Spacer [106]). Place the Right Handrail

Spacer on the right Upright (110).

Connect the Upright Wire Harness (101) and the TV

Cable (104) to the two wires extending from the Console

Base (76). Insert the connectors, the Upright Wire

Harness, and the TV Cable into the hole in the Console

Base (refer to inset drawing B).

Set the Handrail (89) on the Right Handrail Spacer (107),

being careful not to pinch the Upright Wire Harness (101)

and the TV Cable (104).

101

110

107

104

107

106

101

104

107

6. Attach the Latch Assembly (109) to the left Upright (110)

with two Latch Screws (86).

109

110

7. Note the location of the 75 ohm antenna terminal on

the treadmill. For the television to operate properly, an

antenna, a CATV cable, or a VCR must be connected

to the 75 ohm antenna terminal.

If you are using an antenna, it must be properly con-

nected and adjusted for optimal reception. Refer to AN-

TENNA CONNECTIONS on page 22 to properly connect

an antenna. If you are using a CATV cable, refer to

CATV CABLE CONNECTION on page 22 to properly con-

nect the cable. If you are using a VCR, refer to HOW TO

CONNECT A VCR on page 24 to properly connect the

VCR. The VCR must be turned on, a videocassette

must be properly inserted, and the VCR must be play-

ing. Refer to your VCR user’s manual for operating in-

structions.

75 Ohm Antenna

Terminal

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Comments to this Manuals

No comments

HealthRider T90 User Manual Page 8

Comments to this Manuals

Related products and manuals for Treadmills HealthRider T90