HealthRider T90 User Manual download pdf (Page 4)

21. Do not change the incline of the treadmill by

placing objects under the treadmill.

22. When folding or moving the treadmill, make

sure that the storage latch is fully closed.

23. When using iFIT.com CDs and videos, an

electronic “chirping” sound will alert you

when the speed and/or incline of the treadmill

is about to change. Always listen for the

“chirp” and be prepared for speed and/or in-

cline changes. In some instances, the speed

and/or incline may change before the per-

sonal trainer describes the change.

24. When using iFIT.com CDs and videos, you

can manually override the speed and incline

settings at any time by pressing the speed

and incline buttons. However, when the next

“chirp” is heard, the speed and/or incline will

change to the next settings of the CD or video

program.

25. Always remove iFIT.com CDs and videos from

your CD player or VCR when you are not

using them.

26. Inspect and properly tighten all parts of the

treadmill regularly.

27. Never insert or drop any object into any

opening.

28.

DANGER:Always unplug the power

cord immediately after use, before cleaning

the treadmill, and before performing the main-

tenance and adjustment procedures de-

scribed in this manual. Never remove the

motor hood unless instructed to do so by an

authorized service representative. Servicing

other than the procedures in this manual

should be performed by an authorized service

representative only.

29. This treadmill is intended for in-home use

only. Do not use this treadmill in any commer-

cial, rental, or institutional setting.

30. If an outside antenna or cable system is con-

nected, be sure that the antenna or cable sys-

tem is grounded to provide some protection

against voltage surges and built-up static

charges. Section 810 of the National

Electrical Code, ANSI/NFPA No. 70-1984, pro-

vides information with respect to proper

grounding of the mast and supporting struc-

ture, grounding of the lead-in wire to an an-

tenna discharge unit, size of grounding con-

ductors, location of antenna discharge unit,

connection to grounding electrodes, and re-

quirements for the grounding electrode.

31. An outside antenna system should not be lo-

cated in the vicinity of overhead power lines

or other electric light or power circuits, or

where it can fall into such power lines or cir-

cuits. When installing an outside antenna

system, extreme care should be taken to keep

from touching such power lines or circuits,

as contact with them might be fatal.

32. To reduce the risk of electric shock, do not re-

move the cover or back of the TV. There are

no user serviceable parts inside. Refer servic-

ing to qualified service personnel.

33. Upon completion of any service or repairs to

the treadmill or TV, ask the service technician

to perform safety checks to determine that

the unit is in proper operating condition (refer

to the drawing on page 6).

• Use No. 10 AWG (5.3mm

) copper, No. 8

AWG (8.4mm

) aluminum, No. 17 AWG

(1.0mm

) copper-clad steel or bronze wire,

or larger as a ground wire.

• Secure antenna lead-in and ground wires to

house with stand-off insulators spaced from

4 to 6 feet (1.22 to 1.83m) apart.

• Mount antenna discharge unit as close as

possible to where the lead-in enters the

house.

• Use a jumper wire not smaller than No. 6

AWG (13.3mm

) copper, or the equivalent

when a separate antenna-grounding elec-

trode is used. See NEC Section 810-21 (j).

Note to CATV system installer: This reminder is

provided to call the CATV system installer’s at-

tention to Article 820-40 of the NEC that provides

guidelines for proper grounding and, in particu-

lar, specifies that the cable ground shall be con-

nected to the grounding system of the building,

as close to the point of cable entry as practical.

1 2 3 4 5 6 7 8 9 ... 33 34

Comments to this Manuals

No comments

HealthRider T90 User Manual Page 4

Comments to this Manuals

Related products and manuals for Treadmills HealthRider T90