BASIC TELEVISION OPERATION
Insert the key fully into the console.
See GETTING STARTED on page 11.
Press the Power button below the television to
turn on the television.
When the button is
pressed, the channel
display will light and
show the most re-
cently selected
channel.
Press the Channel buttons to select the
desired channel.
To change the channel, press the Channel but-
tons. Note: The television is equipped with a
channel memorizing function that allows you to
step up or down from the current channel to the
next channel set into memory. Before channels
can be selected in this way, they must be set into
the television’s memory. See HOW TO MEMO-
RIZE CHANNELS at the right.
Press the Volume buttons to adjust the volume.
When the Volume
buttons are pressed,
the selected volume
level will appear in
the channel display
for a few seconds.
There are 11 volume
levels (0 though 10). Note: To use earphones or
headphones (not included), plug them into the
jack below the console.
When you are finished using the television,
press the Power button below the television.
When the button is pressed, the channel display
will darken.
When you are finished using the treadmill, re-
move the key.
Remove the key from the console and put it in a
secure place. Next, move the on/off switch near
the power cord to the off position and unplug the
power cord.
HOW TO MEMORIZE CHANNELS
Follow the steps below to set channels into the televi-
sion’s memory.
Press the Stop button while inserting the key
fully into the console.
The console will turn on and the information mode/
demo mode will be selected. (See THE INFOR-
MATION MODE/DEMO MODE on page 21.)
Press the Stop button and set the television for
a cable connection or an antenna connection.
When the button is
pressed, the letters
cAbL (cable) or Air
will appear in the
Time/Pace display. If
you have connected
a CATV cable to the treadmill, cAbL should be se-
lected. If you have connected an antenna, Air
should be selected. Press the Power button below
the television to change the setting, if necessary.
Press the Channel + button to scan and
memorize channels.
When the button is pressed, the television will
begin scanning all of the channels available in
your area. When no broadcast signal is detected
on a channel, the channel will be skipped. When a
signal is detected, the channel will be stored in
memory, a tone will sound, and the next channel
will be selected. This process will be repeated
until the highest channel is reached. A series of
tones will then sound.
Press the Stop button and erase or add
channels.
After all valid channels available in your area have
been set into memory, you can erase unwanted
channels or manually add channels.
To erase a channel,
first press the
Channel buttons until
the unwanted chan-
nel appears in the
channel display. The
letters dEL (delete) will appear in the Time/Pace
display. Press the Power button below the televi-
sion to delete the channel.
4
3
2
1
6
5
4
3
2
1
(34 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals