HealthRider H450I User Manual download pdf (Page 23)

With the heUpof a second person, carefully raise the

Uprights (70, 76) as shown, Carefully pivot the Hood

(28) off,

Locate the Reed Switch (39) and the Magnet (6) on

the bft side of the Pulley (7), Turn the Pulley until the

Magnet is aligned with the Reed Switch, Make sure

that the gap between the Magnet and the Reed

Switch is about 1/8", if necessary, bosen the Screw

(11), move the Reed Switch slightly, and then

retighten the Screw, Reattach the Hood, and run the

treadmHUfor a few minutes to check for a correct

speed reading,

1/8"-

11/

[

Top

View

PROBLEM: The walking belt slows when walked on

SOLUTION: a, Use only a singleooutlet surge suppressor that meets all the specifications described on page 12,

if the walking belt is overtightened, treadmill perforo

mance may decrease and the walking belt may beo

come damaged, Remove the key and UNPLUG THE

POWER CORD, Using the hex key, turn both rear

roller bolts counterclockwise, 1/4 of a turn, When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 2 to 3 inches

above the walking platform, Be careful to keep the

walking belt centered, Then, plug in the power cord,

insert the key, and run the treadmill for a few minutes,

Repeat until the walking belt is properly tightened,

Rear Roller Bolts

c, if the walking belt still slows when walked on, please see the front cover of this manual,

PROBLEM: The waJking belt is off-center or slips when walked on

SOLUTION: a,

If the waJking beJt is off-center, first remove the key

and UNPLUG THE POWER CORD, If the walking

belt has shifted to the Jeft, use the hex key to turn

the left rear roller bolt clockwise 1/2 of a turn; if the

walking belt has shifted to the right, turn the left

bolt counterclockwise 1/2 of a turn, Be careful not to

overtighten the walking belt, Then, plug in the power

cord, insert the key, and run the treadmill for a few

minutes, Repeat until the walking belt is centered,

If the walking belt slips when walked on, first re-

move the key and UNPLUG THE POWER CORD,

Using the hex key, turn both rear roller bolts clock°

wise, 1/4 of a turn, When the walking belt is correctly

tightened, you should be able to lift each edge of the

walking belt 2 to 3 inches above the walking platform,

Be careful to keep the walking belt centered, Then,

plug in the power cord, insert the key, and carefully

walk on the treadmill for a few minutes, Repeat until

the walking belt is properly tightened,

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comments to this Manuals

No comments

HealthRider H450I User Manual Page 23

Comments to this Manuals

Related products and manuals for Treadmills HealthRider H450I