HealthRider H450I User Manual download pdf (Page 15)

Follow your progress with the display.

When the

manual __

mode is se- m

bcted, the

bwer part of Track

the dispUay

wHUshow a

1/4-mile track. As you waUkor run, the indicators

around the track wH]appear in succession until the

entire track appears. The track wH]then disappear

and the indicators wH]again begin to appear in

succession,

The left side of the dis-

play wiii show the incline

level of the treadmill, the

elapsed time, and the

distance you have

walked or run, Note:

When a program is selected, the display wiii show

the time remaining in the program instead of the

elapsed time,

The right side of the

display wiii show the

speed of the walking

belt, the approximate

number of calories you

have burned, and your

pace (in minutes per mile), The display will also

show your heart rate when you use the handgrip

pulse sensor or the optional chest pulse sensor,

To reset the display, press the Stop button, re-

move the key, and then reinsert the key.

Note: The console can

display speed and dis-

tance in either miles or

kilometers, To determine

which unit of measure°

ment is selected, hold

down the Stop button while inserting the key into

the console, An "E" for English miles or an "M" for

metric kilometers will appear in the right side of the

display, Press the Quick Speed increase button to

change the unit of measurement, When the de-

sired unit of measurement is selected, remove the

key, Note: For simplicity, aH instructions in this

section refer to miles.

Measure your heart rate if desired.

Note: if you

use the

handgrip

pulse sensor

and the op-

tional chest

Contacts

pulse sensor

at the same

time, the

console will not display your heart rate accurately,

Before using the handgrip pulse sensor, remove

the clear plastic film from the metal contacts, in

addition, make sure that your hands are clean,

To measure your heart rate, stand on the foot

rails and hold the metal contacts on the

handrail--avoid moving your hands. When your

pulse is detected, the heart symbol in the right side

of the display will appear, one or two dashes will

appear, and then your heart rate will be shown.

For the most accurate heart rate reading, con-

tinue to hotd the contacts for about 15 sec-

onds.

Turn on the fan if desired.

To turn on the fan at low speed, press the Cool

Breeze Fan button. To turn on the fan at high

speed, press the button a second time. To turn off

the fan, press the button a third time. Note: if the

fan is left on when the walking belt is stopped, the

fan will automatically turn off after a few minutes.

When you are finished exercising, remove the

key from the consote.

Step onto the foot rails, press the Stop button, and

adjust the incline of the treadmill to the Jowest

setting. The incline must be at the Jowest setting

when the treadmill is fotded to the storage posi-

tion or the treadmill will be damaged. Next, re-

move the key from the console and put it in a se-

cure place. Note: If the display remains Jit after

the key is removed, the consoJe is in the

"demo" mode. See page 19 and turn off the

demo mode.

When you are finished using the treadmill,

switch the reset/off circuit breaker to the off

position and unptug the power cord.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

HealthRider H450I User Manual Page 15

Comments to this Manuals

Related products and manuals for Treadmills HealthRider H450I