HealthRider HREL3226.0 User Manual download pdf (Page 8)

9. While another person holds the Console (10) near

the Upright (2), connect the Upper Wire Harness

(18) to the wire harness on the Console.

Attach the Console (10) to the Upright (2) with four

M4 x 16mm Screws (60). Be careful not to pinch

the wire harnesses.

Attach the Water Bottle Holder (17) to the Upright

(2) with two M4 x 22mm Screws (66).

8. The Console (10) requires four “D” batteries (not

included); alkaline batteries are recommended.

IMPORTANT: If the elliptical exerciser has been

exposed to cold temperatures, allow it to warm

to room temperature before inserting batteries

into the Console. If you do not do this, the con-

sole displays or other electronic components

may become damaged. Remove the battery cover

from the Console. Insert four batteries into the

Console; make sure that the batteries are orient-

ed as shown by the diagram inside the battery

compartment. Then, reattach the battery cover.

Batteries

Battery

Cover

7. Attach the Left Pedal Arm (21) to the left Upper

Body Arm (6) with an M8 x 23mm Button Screw

(65), an M8 Washer (64), and a Pedal Leg Cover

(23).

Apply grease to a Large Wave Washer (20) and

slide it onto the Left Crank Arm (42). Then, attach

the Left Pedal Arm (21) to the Left Crank Arm with

an M8 x 25mm Patch Screw (70) and an M8 Large

Washer (81).

Repeat this step for the other side of the elliptical

exerciser.

See step 3. Tighten the four M8 x 19mm Patch

Screws (73).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

HealthRider HREL3226.0 User Manual Page 8