HealthRider H500i User Manual download pdf (Page 8)

7.

Set the console assembly on the Handrail (20).

Be careful to avoid pinching any of the wires.

Make sure that the ground wire (see step 5)

and the wire from the console assembly (see

step 6) are in the indicated channel.

Hand tighten five Screws (3) into the Handrail

(20) and the console assembly. Do not put

Screws into the two indicated holes. Start all

five Screws, but do not tighten them yet.

6. While the second person continues to hold the

console assembly, locate the wire underneath

the console assembly.

Connect the wire from the console assembly to

the Upright Wire Harness (77).

Make sure to

connect the connectors properly (see the

inset drawing). The connectors should slide

together easily and snap into place. If they do

not, turn one connector and try again. IF THE

CONNECTORS ARE NOT CONNECTED

PROPERLY, THE CONSOLE MAY BE DAM-

AGED WHEN THE POWER IS TURNED ON.

Then, insert the connectors downward into the

Handrail (20).

8

Console Assembly

3

3

No screws

3

20

77

Console

Assembly

77

20

7

5. While a second person holds the console as-

sembly near the Handrail (20), attach the ground

w

ire to the indicated hole in the Handrail with a

Ground Screw (33).

20

H

ole

Ground

Wire

Console

Assembly

33

5

6

Wire

Channel

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments